1- Fasten the background into position. Mark the background base in the glass with a marker pen and take out the background of the aquarium.
2- Put silicone on the base of the aquarium following the line marked with the marker pen but separated of the line about a centimeter backward out so that the background base is above the silicone.
3- Put the background in the aquarium y dropping it over the silicone and leave to dry for some prudential time.
4- It’s easier reach all of the corners if you use a curved spout. Start by heating the spout. When the spout is warm enough bend in an angle of almost 90 degrees and put the silicone on the background sides from down to up.
5- Wait for 12 - 24 hours until the silicone has cured. Then you can start up the aquarium.
Manufacturing of models, moulds and decorative and industrial pieces